Shop parts
F010System codeCritical: machine stops

Kyocera ECOSYS M2040dn error F010 and F020: program or RAM error

Applies to: Kyocera ECOSYS M2040dn, Kyocera ECOSYS M2135dn, Kyocera ECOSYS M2635dn, Kyocera ECOSYS M2635dw, Kyocera ECOSYS M2735dw, Kyocera ECOSYS M2540dn, Kyocera ECOSYS M2540dw, Kyocera ECOSYS M2640idw

Codes covered on this page: F010, F020

Quick answer

Kyocera ECOSYS M2040dn error F010 means the program read from flash memory came back corrupt, and F020 means the RAM failed its check at start-up. In both cases the program did not start properly. First switch off, unplug, wait at least 5 seconds and switch on again.

What does F010 mean?

When the printer starts, it loads its program from flash memory and tests its RAM. F010 shows when the program data read from flash is garbled. F020 shows when the RAM read/write check fails during start-up. The manual gives the same three checks for both codes, so they share this page. The same code and checks apply to the ECOSYS M2135dn, M2635dn, M2635dw, M2735dw, M2540dn, M2540dw and M2640idw, since Kyocera covers all of them in one service manual.

What causes F010?

  • Program did not start properly

    A temporary start-up fault that a full power reset may clear.

  • Backup RAM data is faulty

    Stored data is corrupt and needs to be reset with U021.

  • Main/engine PWB fault

    The board that holds the flash memory and RAM has failed.

What can you check yourself?

  1. 1

    Full power reset

    Switch off at the power switch and pull the plug. Wait at least 5 seconds, plug in and switch on.

  2. 2

    If the code comes back

    Write down the exact code shown, switch the printer off and call a technician. The other checks are inside the machine.

Safety: Before anyone opens the machine to work on boards or cables, switch it off and pull the plug. Part of the machine stays powered while the switch is off, so the plug must come out.

Steps for a technician

  1. 1

    Reset the main power

    Switch off, unplug, wait 5 seconds, then reconnect and switch on.

  2. 2

    Run U021

    Use maintenance mode U021 to reset the backup RAM data.

  3. 3

    Replace the main/engine PWB

    If the code remains, fit a new main/engine PWB.

Need a part for this?

The store does not list the main/engine PWB named for this code, so please ask on WhatsApp for availability.

Ask on WhatsApp: +91 88899-15080

When should you call a technician?

Call a technician if F010 or F020 shows again after a power reset. The next steps need maintenance mode and possibly a new main board.

Questions people ask

What is error F010 on a Kyocera M2040dn?
F010 is a program read error. The Kyocera ECOSYS M2040dn found corrupt data while reading its program from flash memory at start-up.
What is error F020 on a Kyocera printer?
F020 is a RAM read/write error. The RAM check that runs when the machine starts did not pass.
How do I fix Kyocera F010 or F020?
Start with a full power reset. If it returns, a technician runs U021 to reset the backup data, and replaces the main/engine PWB if that does not help.

Related codes

See all Kyocera ECOSYS M2040dn error codes