Shop parts
F050System codeCritical: machine stops

Kyocera ECOSYS M2040dn error F050: engine program will not start

Applies to: Kyocera ECOSYS M2040dn, Kyocera ECOSYS M2135dn, Kyocera ECOSYS M2635dn, Kyocera ECOSYS M2635dw, Kyocera ECOSYS M2735dw, Kyocera ECOSYS M2540dn, Kyocera ECOSYS M2540dw, Kyocera ECOSYS M2640idw

Quick answer

Kyocera ECOSYS M2040dn error F050 is an engine main program error: the print engine program cannot start up. The first cause the manual names is a bad engine ROM checksum. Start with a full power reset. If F050 returns, a technician updates the engine firmware and checks the EEPROM.

What does F050 mean?

The print engine runs its own program, stored on the main/engine PWB. F050 shows when that program fails to start, for example because its ROM checksum does not match. The manual checks a power reset first, then the engine firmware, the EEPROM seating and finally the board. The same code and checks apply to the ECOSYS M2135dn, M2635dn, M2635dw, M2735dw, M2540dn, M2540dw and M2640idw, since Kyocera covers all of them in one service manual.

What causes F050?

  • Engine ROM checksum fault

    The check on the engine program failed; a full power reset may clear it.

  • Firmware not up to date

    The engine firmware is older than the latest version.

  • EEPROM not seated

    The EEPROM on the main/engine PWB is not properly fitted.

  • Main/engine PWB fault

    The board has failed.

What can you check yourself?

  1. 1

    Full power reset

    Switch off at the power switch and pull the plug. Wait at least 5 seconds, plug in and switch on.

  2. 2

    If the code comes back

    Write down the exact code shown, switch the printer off and call a technician. The other checks are inside the machine.

Safety: Before anyone opens the machine to work on boards or cables, switch it off and pull the plug. Part of the machine stays powered while the switch is off, so the plug must come out.

Steps for a technician

  1. 1

    Reset the main power

    Switch off, unplug, wait 5 seconds, then reconnect and switch on.

  2. 2

    Update the engine firmware

    Upgrade the engine firmware to the latest version.

  3. 3

    Refit the EEPROM

    Reseat the EEPROM on the main/engine PWB.

  4. 4

    Replace the main/engine PWB

    If F050 remains, fit a new main/engine PWB.

Need a part for this?

The store does not list the EEPROM or main/engine PWB named for this code, so please ask on WhatsApp for availability.

Ask on WhatsApp: +91 88899-15080

When should you call a technician?

Call a technician if F050 shows again after a power reset. The next steps are a firmware update and work on the main/engine PWB.

Questions people ask

What does F050 mean on a Kyocera M2040dn?
On a Kyocera ECOSYS M2040dn, F050 means the engine program could not start, often because its ROM checksum check failed.
How do I clear Kyocera F050?
Switch off, unplug, wait at least 5 seconds and switch on. If it comes back, a technician updates the engine firmware and then checks the EEPROM and the main/engine PWB.
Is F050 the same as F040?
No. F040 is a communication fault between the controller and the engine, while F050 means the engine program itself will not start.

Related codes

See all Kyocera ECOSYS M2040dn error codes