Kyocera ECOSYS M2040dn J0101, J0104, J0105, J0106: jam caused by software
Applies to: Kyocera ECOSYS M2040dn, Kyocera ECOSYS M2135dn, Kyocera ECOSYS M2635dn, Kyocera ECOSYS M2635dw, Kyocera ECOSYS M2735dw, Kyocera ECOSYS M2540dn, Kyocera ECOSYS M2540dw, Kyocera ECOSYS M2640idw
Codes covered on this page: J0101, J0104, J0105, J0106
Quick answer
Kyocera ECOSYS M2040dn codes J0101, J0104, J0105 and J0106 are jams caused by software, not by stuck paper. The firmware did not start correctly. First switch the printer off, unplug it, wait at least 5 seconds and power it back on. If the code returns, the firmware needs upgrading.
What does J0101 mean?
These four codes share one meaning in the Kyocera manual: the firmware did not activate properly, so the printer stopped as if paper had jammed. There is no mechanical check listed for them. The manual's fix is a power reset and then a firmware upgrade. The same code and steps apply to the ECOSYS M2135dn, M2635dn, M2635dw, M2735dw, M2540dn, M2540dw and M2640idw, which share one Kyocera service manual.
What causes J0101?
Controller did not start properly
A full power reset is enough when the controller simply failed to activate.
Firmware problem
If the code keeps returning, the firmware is not activating properly and needs to be upgraded to the latest version.
What can you check yourself?
- 1
Do a full power reset
Turn the power switch off and pull out the plug. Wait at least 5 seconds, plug back in and switch on.
- 2
Remove any paper shown on the panel
If the panel still points to a location, clear the sheet there and close the covers.
- 3
Note the code
If the same code returns, write it down for your technician or dealer.
Steps for a technician
- 1
Reset the main power
Switch off, unplug, wait 5 seconds, then reconnect and switch on.
- 2
Upgrade the firmware
Install the latest firmware version for the machine.
Need a part for this?
No spare part is involved in the manual's fix for these codes; if you need help with a firmware upgrade, please ask on WhatsApp.
Ask on WhatsApp: +91 88899-15080When should you call a technician?
Call a technician or your dealer if the code comes back after a full power reset, because the firmware then needs to be upgraded.
Questions people ask
- What does J0101 mean on a Kyocera M2040dn?
- J0101 on a Kyocera ECOSYS M2040dn is a paper jam caused by a software factor. The firmware did not start properly, so no physical jam needs to be present.
- Are J0104, J0105 and J0106 different from J0101?
- No. The Kyocera manual treats J0101, J0104, J0105 and J0106 as one group with the same cause and the same two steps: power reset, then firmware upgrade.
- Will a firmware update fix Kyocera J0101?
- If a full power reset does not clear it, the Kyocera manual's next step is to upgrade the firmware to the latest version.