Shop parts
J9010Paper jam codeWarning

Kyocera ECOSYS M2040dn J9010: document processor open during feeding

Applies to: Kyocera ECOSYS M2040dn, Kyocera ECOSYS M2135dn, Kyocera ECOSYS M2635dn, Kyocera ECOSYS M2635dw, Kyocera ECOSYS M2735dw, Kyocera ECOSYS M2540dn, Kyocera ECOSYS M2540dw, Kyocera ECOSYS M2640idw

Quick answer

Kyocera ECOSYS M2040dn code J9010 means the printer detected the document processor as open while it was feeding originals. The likely cause is a document processor that is not fully closed or sits badly. First remove the originals, close the document processor firmly and try again. If it persists, the open/close sensor needs checking.

What does J9010 mean?

A DP open/close sensor tells the machine the document processor is shut. J9010 appears when that sensor reports open during original feeding. The manual checks how the document processor sits and closes, then the sensor wiring, the sensor and the main/engine PWB. The same code and steps apply to the ECOSYS M2135dn, M2635dn, M2635dw, M2735dw, M2540dn, M2540dw and M2640idw, which share one Kyocera service manual.

What causes J9010?

  • Document processor not closed or fitted badly

    It does not close securely, is not attached properly, or its cover is deformed.

  • Wiring

    Loose DP open/close sensor connector at main/engine PWB YC34.

  • Open/close sensor fault

    The DP open/close sensor is dirty, loose or faulty.

  • Main/engine PWB fault

    Checked last.

What can you check yourself?

  1. 1

    Close the document processor

    Remove the originals, then lower the document processor fully and make sure it sits flat.

  2. 2

    Check for damage

    If the document processor looks bent or will not sit flat, do not force it; call a technician.

  3. 3

    Try again

    Reload the originals and scan again.

Safety: Switch off and unplug the machine before anyone removes document processor covers or works on the main/engine PWB.

Steps for a technician

  1. 1

    Check the document processor

    Make sure it closes securely and refit it if needed. Correct or replace a deformed cover.

  2. 2

    Check wiring

    Reseat DP open/close sensor to main/engine PWB (YC34) and replace a wire with no continuity.

  3. 3

    Check the DP open/close sensor

    Clean, refit and reconnect it, and replace it if it still fails.

  4. 4

    Replace the main/engine PWB

    As the last step.

Need a part for this?

The store does not list the DP open/close sensor or document processor cover for this code, so please ask on WhatsApp if you need one.

Ask on WhatsApp: +91 88899-15080

When should you call a technician?

Call a technician if J9010 returns with the document processor fully closed.

Questions people ask

What does J9010 mean on a Kyocera M2040dn?
J9010 on a Kyocera ECOSYS M2040dn means the document processor was detected as open while originals were being fed.
My document feeder is closed but J9010 shows. Why?
The Kyocera manual checks whether the document processor is attached properly or deformed, then the DP open/close sensor and its wiring.
Is J9010 the same as J0110?
No. J0110 is the right cover of the printer opening during printing. J9010 is the document processor opening during original feeding.

Related codes

See all Kyocera ECOSYS M2040dn error codes